Base Card – Cherry Cobbler – 8 1/4″ x 4 1/8″ or 21cm x 15cm –
Scored in middle & folded in half
Layer 1 – DSP – 3″ x 4″ or 10.5cm x 7.5cm
Layer 2 – Island Indigo – 1″ x 4″ or 1.5cm x 10.5cm
Layer 3 – Basic Black – 4″ x 2″ or 10.5cm x 5cm
Layer 4 – DSP – 3 7/8″ x 1 7/8″ or 10cm x 4.5cm
Layer 5 – River Rock – 3 1/2″ x 2 1/2″ or 9cm x 6.5cm
Layer 6 – DSP – 3 3/8″ x 2 3/8″ or 8.5cm x 6cm
Layer 7 – Island Indigo – 4″ x 2 1/2″ or 10cm x 6.5cm
Layer 8 – Very Vanilla – 3 7/8″ x 2 3/8″ or 9.5cm x 6cm
Using my Eyelet Border Punch, I punched along the side of a scrap piece of Basic Black Cardstock & adhered to the larger piece of DSP prior to adhering to the Base Card – Cherry Cobbler using Snail Adhesive.
|Envelope & Inside Card…|
I adhered both pieces of DSP to the corresponding Cardstock with Snail Adhesive – DSP Red to the Basic Black & Black DSP to River Rock. This piece was then adhered to the longer piece of DSP with Snail Adhesive & set aside.
I stamped my image onto Very Vanilla Cardstock with Staz-On Ink. I meant to do a little embossing, but completely forgot about it until I had assembled my card. Oh well, next time! I adhered the stamped piece to both pieces of DSP ensuring that it overlapped. I didn’t quiet adhere permanently but left a little so that I could tuck the ends of my ribbon under.
The whole section was then adhered to the Base Card. A bow was tied & adhered to the card with a Mini-Glue Dot.
The greeting was stamped in Staz-On Ink. Again, the embossing was forgotten.